How to Install an Avinox Wheel Sender (Step-by-Step)

How to install an Avinox wheel sender

Fitting an Avinox Delimiter wheel sender takes about two minutes. Here is the process.

1. Confirm your drive system (Avinox M1, M2 or M2S) and that your build is standard.
2. Locate the wheel and the mounting point shown in the fitting guide.
3. Position the chip so it sits cleanly without fouling the rotor or caliper.
4. Secure it and power on the bike.
5. Check the display reads correctly, then test on private land, building speed gradually.

Tips for a clean install

Keep the chip clear of moving parts, and re-check it is secure after your first ride. Because it is clip-on, you can remove it any time to return to stock.

New to this? Start with our complete guide to delimiting a DJI Avinox.

Private-property / off-road use only.

🛒 Shop Now — Avinox Delimiter Chip